Hyundai Elantra: Vehicle Information / Vehicle Identification Number (vin), Vehicle Certification Label
Vehicle Identification Number (VIN)
Frame number
The vehicle identification number (VIN) is the number used in registering your car and in all legal matters pertaining to its ownership, etc.
The number is punched on the floor under the passenger seat.
VIN label
The VIN is also on a plate attached to the top of the dashboard. The number on the plate can easily be seen through the windshield from outside.
Vehicle Certification Label
The vehicle certification label attached on the driver’s side center pillar gives the Vehicle Identification Number (VIN).
Recommended Lubricants and Capacities
To help achieve proper engine and powertrain performance and durability, use
only
lubricants of the proper quality. The correct lubricants also help promote
engine
efficiency that results in improved fuel economy...
Tire Specification and Pressure Label, Engine Number
Tire Specification and Pressure Label
The tires supplied on your new
vehicle are chosen to provide the best
performance for normal driving.
The tire label located on the driver’s
side center pillar gives the tire pressures
recommended for your car...
Other information:
Hyundai Elantra (CN7) 2021-2025 Service Manual: Joint Assembly (Wheel side)
Repair procedures RemovalThe type can replace the wheel side joint boot1.Remove the front drive shaft.(Refer to Driveshaft Assembly - "Front Driveshaft")2.Remove the trans axle side joint.(Refer to Driveshaft Assembly - "Transaxl Joint")3.Remove the dynamic damper...
Hyundai Elantra (CN7) 2021-2025 Service Manual: Rear torsion beam axle
Components and components location Components1. Torsion beam axle2. Rear torsion beam chassis bracket Repair procedures Removal[Rear disc brake parking cable type]1.Loosen the wheel nuts slightly.Raise the vehicle, and make sure it is securely supported...
Categories
- Manuals Home
- 7th Gen Hyundai Elantra Owners Manual
- 7nd Gen Hyundai Elantra Service Manual
- System disabled
- Fuel gauge
- Integrated Thermal Management Module (ITM)
- Recommended Lubricants and Capacities
- Control Cable
Rear center seat belt
When using the rear center seat belt, the buckle with the “CENTER” mark must be used.
WARNING
Make sure that the seatback is locked in place when using the rear center seat belt.
If not, the seatback may move when there is a sudden stop or collision, which could result in serious injury.
