Hyundai Elantra Owners and Service Manuals

Hyundai Elantra: Manual heating and air conditioning / Air intake control

Recirculated air position

With the recirculated air position selected, air from the passenger compartment will be drawn through the heating system and heated or cooled according to the function selected.

Outside (fresh) air position

With the outside (fresh) air position selected, air enters the vehicle from outside and is heated or cooled according to the function selected.

Information

Operating the system primarily in Fresh mode is recommended. Use Recirculation mode temporarily only when needed.

Prolonged operation of the heater in Recirculation mode and without the A/C ON can cause fogging of the windshield.

In addition, prolonged use of the A/C ON in Recirculation mode may result in excessively dry, dehumidified air in the cabin and may promote formation of musty vent odor due to stagnant air.

WARNING

  • Continued use of the climate control system operation in Recirculation mode for a prolonged period of time may cause drowsiness to the occupants in the cabin. This may lead to loss of vehicle control which may lead to an accident.
  • Continued use of the climate control system operation in Recirculation mode with the A/C OFF may allow humidity to increase inside the cabin. This may cause condensation to accumulate on the windshield and obscure visibility.
  • Do not sleep in your vehicle or remain parked in your vehicle with the windows up and either the heater or the air conditioning ON for prolonged periods of time. Doing so may increase the levels of carbon dioxide in the cabin which may lead to serious injury or death.

    Temperature control

    The temperature will increase by turning the knob to the right. The temperature will decrease by turning the knob to the left. The temperature will increase or decrease by 1°F (0...

    Fan speed control

    The fan speed can be set to the desired speed by using the fan speed control toggle switch. More air is delivered with higher fan speeds. Pressing the OFF button turns off the fan...

    Other information:

    Hyundai Elantra (CN7) 2021-2025 Service Manual: AVN(Audio Video Navigation) head unit


    Components and components location ComponentsMiddle EastConnector Pin Information No Connector A (Int AMP) Connector A (Ext AMP) Connector B 1Rear left speaker (+)--2Reart left speaker (-)-MIC Signal (+)3-AMP Navi Voice (+)-4-AMP SPDIF (HI)-5--Antenna Powr6Camera PowerCamer..

    Hyundai Elantra (CN7) 2021-2025 Service Manual: Rear Oil Seal


    Components and components location Components1. Rear oil seal Repair procedures Replacement1.Remove the drive plate.(Refer to Cylinder Block - "Drive Plate")2.Remove the rear oil seal (A).3.Apply engine oil on the edge of new rear oil seal.4.Using SSTs (09231-H1100, 09231-2B200), install the new rear oil seal. When assembling, the surface of the oil seal shall coincide with the surface..

    Categories

    Manual climate control system

    To defog inside windshield

    [A] : Type A, [B] : Type B

    1. Select any fan speed except “0” position.

    2. Select the desired temperature.

    3. Select the or position.

    read more

    Copyright © 2025 www.helantra7.com