Hyundai Elantra Owners and Service Manuals

Hyundai Elantra: Electronic Stability Control (ESC) / Indicator lights

When the ignition switch is placed to the ON position, the ESC indicator light illuminates, then goes off if the ESC system is operating normally.

The ESC indicator light blinks whenever the ESC is operating.

If ESC indicator light stays on, your vehicle may have a malfunction with the ESC system. When this warning light illuminates have your vehicle checked by an authorized HYUNDAI dealer as soon as possible.

The ESC OFF indicator light comes on when the ESC is turned off.

WARNING

When the ESC is blinking, this indicates the ESC is active:

Drive slowly and NEVER attempt to accelerate. NEVER turn the ESC off while the ESC indicator light is blinking or you may lose control of the vehicle resulting in an accident.

NOTICE

Driving with wheels and tires with different sizes may cause the ESC system to malfunction. Before replacing tires, make sure all four tires and wheels are the same size. Never drive the vehicle with different sized wheels and tires installed.

    ESC operation

    ESC ON condition When the ignition switch is in the ON position, the ESC and the ESC OFF indicator lights illuminate for approximately three seconds...

    ESC OFF usage

    When Driving The ESC OFF mode should only be used briefly to help free the vehicle if stuck in snow by temporarily stopping operation of the ESC to maintain wheel torque...

    Other information:

    Hyundai Elantra (CN7) 2021-2025 Service Manual: Repair procedures


    Adjustment1.After loosening the hinge (A) mounting bolt, adjust the hood (B) by moving it up and down or from side to side and tighten the bolt.2.Adjust the hood height by moving the hood overslam bumpers (C) up and down.3.After loosening the hood latch (D) mounting bolts, adjust the latch by moving it up and down or from side to side...

    Hyundai Elantra (CN7) 2021-2025 Service Manual: Heater Core


    Repair procedures Replacement1.Disconnect the negative (-) battery terminal. 2.Remove the heater and blower assembly.(Refer to Heater - "Heater Unit") 3.Remove the heater core cover (A) after loosening the mounting screws.4.Pull out the heater core (A) from the heater unit...

    Categories

    Air bag collision sensors

    1. SRS control module/Rollover sensor
    2. Front impact sensors
    3. Side impact sensors (acceleration)
    4. Side impact sensors (pressure)

    read more

    Copyright © 2025 www.helantra7.com