Hyundai Elantra Owners and Service Manuals

Hyundai Elantra: Maintenance / Appearance Care. Interior Care

Interior general precautions

Prevent caustic solutions such as perfume and cosmetic oil, from contacting the interior parts because they may cause damage or discoloration. If they do contact the interior parts, wipe them off immediately. See the instructions for the proper way to clean vinyl.

NOTICE

  • Never allow water or other liquids to come in contact with electrical/ electronic components inside the vehicle as this may damage them.
  • When cleaning leather products (steering wheel, seats etc.), use neutral detergents or low alcohol content solutions. If you use high alcohol content solutions or acid/ alkaline detergents, the color of the leather may fade or the surface may get stripped off.

Cleaning the upholstery and interior trim

Vinyl (if equipped)

Remove dust and loose dirt from vinyl with a whisk broom or vacuum cleaner. Clean vinyl surfaces with a vinyl cleaner.

Fabric (if equipped)

Remove dust and loose dirt from fabric with a whisk broom or vacuum cleaner. Clean with a mild soap solution recommended for upholstery or carpets. Remove fresh spots immediately with a fabric spot cleaner. If fresh spots do not receive immediate attention, the fabric can be stained and its color can be affected. Also, its fire-resistant properties can be reduced if the material is not properly maintained.

NOTICE

Using anything but recommended cleaners and procedures may affect the fabric’s appearance and fire-resistant properties.

Leather

• Features of seat leather

-- Leather is made from the outer skin of an animal, which goes through a special process to be available for use. Since it is a natural product, each part differs in thickness or density. Wrinkles may appear as a natural result of stretching and shrinking depending on the temperature and humidity.
-- The seat is made of stretchable fabric to improve comfort.
-- The parts contacting the body are curved and the side supporting area is high which provides driving comfort and stability.
-- Wrinkles may appear naturally from usage. It is not a fault of the products.

CAUTION

  • Wrinkles or abrasions which appear naturally from usage are not covered by warranty.
  • Belts with metallic accessories, zippers or keys inside the back pocket may damage the seat fabric.
  • Make sure not to wet the seat. It may change the nature of natural leather.
  • Jeans or clothes which could bleach may contaminate the surface of the seat covering fabric.

• Caring for the leather seats

-- Vacuum the seat periodically to remove dust and sand on the seat. It will prevent abrasion or damage of the leather and maintain its quality.
-- Wipe the natural leather seat cover often with dry or soft cloth.
-- Use of proper leather protector may prevent abrasion of the cover and helps maintain the color. Be sure to read the instructions and consult a specialist when using leather coating or protective agent.
-- Light colored (beige, cream beige) leather is easily contaminated and the stain is noticeable. Clean the seats frequently.
-- Avoid wiping with wet cloth. It may cause the surface to crack.

• Cleaning the leather seats

-- Remove all contaminations instantly. Refer to instructions below for removal of each contaminant.
-- Cosmetic products (sunscreen, foundation, etc.)
Apply cleansing cream on a cloth and wipe the contaminated spot. Wipe off the cream with a wet cloth and remove water with a dry cloth.
-- Beverages (coffee, soft drink, etc.)
Apply a small amount of neutral detergent and wipe until contaminations do not smear.
-- Oil
Remove oil instantly with absorbable cloth and wipe with stain remover used only for natural leather.
-- Chewing gum
Harden the gum with ice and remove gradually.

Cleaning the seat belt webbing

Clean the belt webbing with any mild soap solution recommended for cleaning upholstery or carpet. Follow the instructions provided with the soap. Do not bleach or re-dye the webbing because this may weaken the seat belt.

Cleaning the interior window glass

If the interior glass surfaces of the vehicle become hazy (that is, covered with an oily, greasy or waxy film), they should be cleaned with glass cleaner. Follow the directions on the glass cleaner container.

NOTICE

Do not scrape or scratch the inside of the rear window. This may result in damage to the rear window defroster grid.

    Corrosion protection

    Protecting your vehicle from corrosion By using the most advanced design and construction practices to combat corrosion, HYUNDAI produces vehicles of the highest quality...

    Emission Control System

    The emission control system of your vehicle is covered by a written limited warranty. Please see the warranty information contained in the Owner’s Handbook & Warranty Information booklet in your vehicle...

    Other information:

    Hyundai Elantra (CN7) 2021-2024 Service Manual: Steering Gear Box


    Repair procedures Removal1.Loosen the wheel nuts slightly.Raise the vehicle, and make sure it is securely supported.2.Remove the front wheel and tire (A) from the front hub. Tightening torque : 107.9 - 127.5 N.m (11.0 - 13.0 kgf...

    Hyundai Elantra (CN7) 2021-2024 Owner's Manual: Rear Cross-Traffic Collision Warning (RCCW)


    Rear Cross-Traffic Collision Warning Assist is designed to help detect vehicles approaching from the left and right side while your vehicle is reversing, and warn the driver that a collision is imminent with a warning message and an audible warning...

    Categories

    Tire Rotation

    To equalize tread wear, HYUNDAI recommends that the tires be rotated according to the maintenance schedule or sooner if irregular wear develops.

    During rotation, check the tires for correct balance.

    When rotating tires, check for uneven wear and damage. Abnormal wear is usually caused by incorrect tire pressure, improper wheel alignment, out-ofbalance wheels, severe braking or severe cornering. Look for bumps or bulges in the tread or side of the tire. Replace the tire if you find any of these conditions. Replace the tire if fabric or cord is visible. After rotation, be sure to bring the front and rear tire pressures to specification and check lug nut tightness (proper torque is 79~94 lbf·ft [11~13 kgf·m]).

    read more

    Copyright © 2024 www.helantra7.com