Hyundai Elantra (CN7): Starting System / Description and operation

Hyundai Elantra (CN7) 2021-2026 Service Manual / Engine Electrical System / Starting System / Description and operation

Description
The starting system includes the battery, starter, solenoid switch, ignition switch, inhibitor switch (A/T), clutch pedal switch (M/T), ignition lock switch, connection wires and the battery cable.
When the ignition key is turned to the start position, current flows and energizes the starter motor's solenoid coil.
The solenoid plunger and clutch shift lever are activated, and the clutch pinion engages the ring gear.
The contacts close and the starter motor cranks.
In order to prevent damage caused by excessive rotation of the starter armature when the engine starts, the clutch pinion gear overruns.

    Troubleshooting    â€¢ The battery must be in good condition and fully charged for this troubleshooting.

    Other information:

    Hyundai Elantra (CN7) 2021-2026 Service Manual: Receiver-Drier

    Repair procedures Replacement1.Remove the condenser.2.Remove the cap (A) on the bottom of the condenser with a L wrench. Tightening torque : 9.81 - 14.71 N.m (1.0 - 1.5 kgf.m, 7.2 - 10.8 lb-ft) 3.Remove the receiver-drier (A) from condenser using a long nose plier.

    Hyundai Elantra (CN7) 2021-2026 Service Manual: Troubleshooting

    TroubleshootingDiagnosis with Diagnostic tool1.In the body electrical system, failure can be quickly diagnosed by using the vehicle diagnostic system (Diagnostic tool).The diagnostic system (Diagnostic tool) provides the following information.1)Fault Code Searching : Checking failure and code number (DTC)2)Data Analysis : Checking the system input/

    Categories

     
    Copyright © 2026 www.helantra7.com - 0.0127