Hyundai Elantra: Air Conditioning System / Compressor oil
Repair procedures
| 1. | The HFC-134a system requires synthetic (PAG) compressor oil whereas the R-12 system requires mineral compressor oil. The two oils must never be mixed. |
| 2. | Compressor (PAG) oil varies according to compressor model. Be sure to use oil specified for the model of compressor. |
Handling of Oil
| 1. | The oil should be free from moisture, dust, metal powder, etc. |
| 2. | Do not mix with other oil. |
| 3. | The water content in the oil increases when exposed to air. After use, seal oil from air immediately. (HFC-134a Compressor Oil absorbs moisture very easily.) |
| 4. | The compressor oil must be stored in steel containers, not in plastic containers. |
Compressor Oil Check
The oil used to lubricate the compressor circulates with the refrigerant.
Whenever replacing any component of the system or a large amount of gas leakage occurs, add oil to maintain the original amount of oil.
Oil total volume in system FD46XG (IDEMITSU) 100 ± 10 g |
Oil Return Operation
There is close affinity between the oil and refrigerant.
During normal operation, part of the oil recirculates with the refrigerant in the system. When checking the amount of oil in the system, or replacing any component of the system, the compressor must run in advance for oil return operation. The procedure is as follows:
| 1. | Open all the doors and engine hood. |
| 2. | Start the engine and air conditioning switch to "ON" and set the blower motor control knob at its highest position. |
| 3. | Run the compressor for more than 20 minutes between 800 and 1,000 rpm in order to operate the system. |
Refrigerant System Service Basics (R-134a)Refrigerant Recovery Use only service equipment that is U.L-listed and is certified to meet the requirements of SAE J2210 to remove HFC-134a(R-134a) from the air conditioning system...
Components and components location
Components Location1. Refrigerant Pipe Assembly
Repair procedures
Replacement1.If the compressor is marginally operable, run the engine at idle speed, and let the air conditioning work for a few minutes, then shut the engine off...
Other information:
DescriptionThe Dual Clutch Transmission (DCT) control system measures required data to identify the state of the control target and computes the appropriate compensation value if adjustment is necessary. The actuator is controlled according to the computed compensation value to obtain desired output...
This gauge indicates the current outside
air temperature by 1°F (1°C).
-- Temperature range: -40°F ~ 140°F
(40°C ~ 60°C)
Note that the temperature indicated
on the LCD display may not change
as quickly as the outside temperature
(there may be a slight delay before the
temperature changes...