Hyundai Elantra Owners and Service Manuals

Hyundai Elantra: Maintenance / Appearance Care. Exterior Care

Exterior general caution

It is very important to follow the label directions when using any chemical cleaner or polish. Read all warning and caution statements that appear on the label.

High-pressure washing

  • When using high-pressure washers, make sure to maintain sufficient distance from the vehicle. Insufficient clearance or excessive pressure can lead to component damage or water penetration.
  • Do not spray the camera, sensors or its surrounding area directly with a high pressure washer. Shock applied from high pressure water may cause the device to not operate normally.
  • Do not bring the nozzle tip close to boots (rubber or plastic covers) or connectors as they may be damaged if they come into contact with high pressure water.
  • Do not use any high-pressure nozzles, which induce either one-direct water stream or water swirling.

Interior Light Bulb Replacement

1. Using a flat-blade screwdriver, gently pry the lens from the interior lamp housing. 2. Remove the bulb by pulling it straight out. WARNING Prior to working on the Interior Lights, ensure that the “OFF” button is depressed to avoid burning your fingers or receiving an electric shock...

Protecting your vehicle’s finish

Washing To help protect your vehicle’s finish from rust and deterioration, wash it thoroughly and frequently at least once a month with lukewarm or cold water...

Other information:

Hyundai Elantra (CN7) 2021-2025 Service Manual: CVVT Oil Temperature Sensor (OTS)


Description and operation DescriptionContinuous Variable Valve Timing (CVVT) system advances or retards the valve timing of the intake and exhaust valve in accordance with the ECM control signal which is calculated by the engine speed and load.By controlling CVVT, the valve over-lap or under-lap occurs, which makes better fuel economy and reduces exhaust gases (NOx, HC) and improves engine perf..

Hyundai Elantra (CN7) 2021-2025 Service Manual: Fuel Pump Motor


Repair procedures Removal1.Remove the fuel pump. (Refer to Fuel Delivery System - "Fuel Pump")2.Disconnect the fuel pump motor connector (A) and fuel sender connector (B).3.Release the fixing hook (A) and then remove the fuel sender (B).4.Remove the fixing clip (A) and then disconnect the fuel feed tube (B).5.Remove the fixing clip (A) and then remove the head assembly (B).6.Release the fixing ..

Categories

Side air bags

Front seat

Your vehicle is equipped with a side air bag in each front seat. The purpose of the air bag is to provide the vehicle’s driver and the front passenger with additional protection than that offered by the seat belt alone.

read more

Copyright © 2025 www.helantra7.com