Hyundai Elantra (CN7): Front Door / Front Door Inside Handle

Hyundai Elantra (CN7) 2021-2026 Service Manual / Body (Interior and Exterior) / Front Door / Front Door Inside Handle

Repair procedures

Removal
1.
Remove the front door trim.
(Refer to Front Door - "Front Door Trim")
2.
Cut the heat-welded part with a knife and loosen the mounting screw (B).
3.
Remove the front door inside handle (A).

   
•
Be careful of breakage and cut the heat-welded part with a knife.
Installation
1.
Install the front door inside handle.
2.
A screw is attached to the cut heat-welded portion.
   
•
Because there is no groove to attach the screw to the heat weld, install the screwdriver in a straight line.

   
•
Front door inside handle mounting screw
(A) : M5, 8mm (7ea)
(B) : Existing screw (M3, 1ea)

    Components and components location Component Location 1. Front door trim Repair procedures Replacement    â€¢ When removing with a flat - tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.

    Components and components location Component Location 1. Front door window glass Repair procedures Replacement1.Remove the front door trim.

    Other information:

    Hyundai Elantra (CN7) 2021-2026 Service Manual: Compressor oil

    Repair procedures Oil Specification1.The HFC-134a system requires synthetic (PAG) compressor oil whereas the R-12 system requires mineral compressor oil. The two oils must never be mixed.2.Compressor (PAG) oil varies according to compressor model. Be sure to use oil specified for the model of compressor.

    Hyundai Elantra (CN7) 2021-2026 Service Manual: Components and components location

    C

    Categories

     
    Copyright © 2026 www.helantra7.com - 0.0144