Hyundai Elantra (CN7): Body Electrical System / Ignition Switch Assembly. Repair procedures

Hyundai Elantra (CN7) 2021-2026 Service Manual / Body Electrical System / Ignition Switch Assembly. Repair procedures

Repair procedures

Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Remove the crash pad lower panel.
(Refer to Body - "Crash Pad")
3.
Remove the steering column upper & Lower shroud.
4.
Remove the ignition switch and disconnecting the Key Warning / immobilizer connector.

5.
If it is necessary to remove the key lock cylinder (A), remove the key lock cylinder (A) after pushing lock pin (B) with key ACC.

6.
Installation is the reverse of removal procedure.
Inspection
1.
Disconnect the ignition switch connector (A) and key warning switch connector (B) from under the steering column.

2.
Check for continuity between the terminals.
3.
If continuity is not specified, replace the switch.

    Repair procedures Removal1.Disconnect the negative (-) battery terminal.2.Remove the crash pad lower panel.(Refer to Body - "Crash Pad Lower Panel")3.

    Other information:

    Hyundai Elantra (CN7) 2021-2026 Service Manual: Description and operation

    DescriptionSystem OverviewThe System offers the following features:– Human / machine interface through a 1-stage button, for terminal switching and engine start.– Control of external relays for ACC / IGN1 / IGN2 terminal switching and STARTER, without use of mechanical ignition switch.

    Hyundai Elantra (CN7) 2021-2026 Service Manual: PM Sensor

    Description and operation DiscriptionMonitor the air quality inside the vehicle in real time (PM sensor) and display the status on the screen.Automatically operate when fine dust concentration is high (Condition: Bet mode + A/C ON + 3rd speed or higher) Components and components location Components Location1.

    Categories

     
    Copyright © 2026 www.helantra7.com - 0.0214