Hyundai Elantra (CN7): Driveshaft and axle / Special service tools

Hyundai Elantra (CN7) 2021-2026 Service Manual / Driveshaft and axle / Special service tools

Special Service Tools
Tool (Number and Name)
Illustration
Use
09495-3K000
Band installer

Installation of ear type boot band
09495-39100
Band installer

Installation of hook type boot band
09568-1S100
Ball joint puller

Remove the ball joint front axle
09495-33000
Puller

Remove the spider assembly from the drive shaft

    Specification Engine Transmission Joint type Max.

    Components and components location Components1. Front knuckle2. Dust cover3. Hub bearing4. Brake disc Repair procedures Removal1.Loosen the wheel nuts slightly.

    Other information:

    Hyundai Elantra (CN7) 2021-2026 Service Manual: Ignition Switch Assembly. Repair procedures

    Repair procedures Replacement1.Disconnect the negative (-) battery terminal.2.Remove the crash pad lower panel.(Refer to Body - "Crash Pad")3.Remove the steering column upper & Lower shroud.4.Remove the ignition switch and disconnecting the Key Warning / immobilizer connector.

    Hyundai Elantra (CN7) 2021-2026 Service Manual: Description and operation

    DescriptionRear Corner Radar is a system that measures the relative speed and distance from the following vehicles by using two electromagnetic wave radar sensors attached to the rear bumper, and detects any vehicle within the blind spot zone and gives off alarm.

    Categories

     
    Copyright В© 2026 www.helantra7.com - 0.0205