| Troubleshooting |
|
Symptom
|
Suspect area
|
Remedy
|
| Charging warning indicator does not light with ignition switch "ON" and engine off. | Fuse blown | Check fuses |
| Light burned out | Replace light | |
| Wiring connection loose | Tighten loose connection | |
| Electronic voltage regulator | Disconnect the voltage regulator to see if light turns off. If light turns off, replace voltage regulator. | |
| Charging warning indicator does not go out with engine running. (Battery requires frequent recharging) | Drive belt loose or worn | Adjust belt tension or replace belt |
| Battery cable loose, corroded or worn | Inspect cable connection, repair or replace cable | |
| Electronic voltage regulator or alternator | Disconnect the voltage regulator or alternator to see if light turns off. If light turns off, replace voltage regulator. | |
| Wiring | Repair or replace wiring | |
| Overcharge | Electronic voltage regulator | Disconnect the voltage regulator to see if light turns off. If light turns off, replace voltage regulator. |
| Voltage sensing wire | Repair or replace wiring | |
| Discharge | Drive belt loose or worn | Adjust belt tension or replace belt |
| Wiring connection loose or short circuit | Inspect wiring connection, repair or replace wiring | |
| Electronic voltage regulator or alternator | Disconnect the voltage regulator or alternator to see if light turns off. If light turns off, replace voltage regulator. | |
| Poor grounding | Inspect ground or repair | |
| Worn battery | Replace battery |
DescriptionThe charging system included a battery, an alternator with a built-in regulator, and the charging indicator light and wire.The Alternator has eight built-in diodes, each rectifying AC current to DC current.
InspectionInspecion Item• Battery efficiency inspection• Battery voltage inspection• Charging voltage insptection• General inspection• Terminal tightening state inspection• Engine/ transaxle ground state inspection• Wiring hareness ground state inspection• Electrical Specified Value Inspection• Vehicle parasitic current inspection • Inspect the battery capacityBattery Efficiency Inspection • Check that the battery cables are connected to the correct terminals.
TroubleshootingProblem Symptoms TableBefore replacing or repairing air conditioning components, first determine if the malfunction is due to the refrigerant charge, air flow or compressor.Use the table below to help you find the cause of the problem. The numbers indicate the priority of the likely cause of the problem.
Description and operation DescriptionThe A/C Pressure Transducer (APT) converts the pressure value of high pressure line into voltage value after measuring it. By converted voltage value, engine ECU controls the cooling fan by operating it high speed or low speed.