Hyundai Elantra (CN7): Steering System / Troubleshooting

Hyundai Elantra (CN7) 2021-2025 Service Manual / Steering System / Troubleshooting

Troubleshooting
Symptom
Probable cause
Remedy
play in steering
Loose yoke plug
Retighten
Loose steering gear mounting bolts
Retighten
Loose or worn tie rod end
Retighten or replace as necessary
Steering wheel does not return properly
Excessive turning resistance of tie rod end
Replace
Yoke plug excessively tight
Adjust
Tie rod and/or ball joint cannot turn smoothly
Replace
Loose mounting of gear box mounting bracket Worn steering shaft joint and/or
Retighten
Worn steering shaft joint and/or body grommet
Correct or replace
Distorted rack
Replace
Damaged pinion bearing
Replace
Rattling or chucking noise in the rack and pinion
Interference with hoses from vehicle body
Reposition
Loose gear box bracket
Retighten
Loose tie rod end and/or ball joint
Retighten
Worn tie rod and/or ball joint
Retighten

    Specifications Item Specification TypeElectric Power Steering SystemSteering gearTypeRack & PinionRack stroke154 mm (6.

    Other information:

    Hyundai Elantra (CN7) 2021-2025 Service Manual: Power Mosfet

    Description and operation DescriptionIt is installed to the DATC and adjusts the fan rpm by precisely controlling the voltage applied to the blower motor. Repair procedures Inspection1.Manually operate the control switch and measure the voltage of the blower motor.

    Hyundai Elantra (CN7) 2021-2025 Service Manual: Repair procedures

    Removal1.Disconnect the negative (-) battery terminal.2.Remove the trunk trim.(Refer to Body - "Trunk Rid Trim")3.Remove the trunk back panel.(Refer to Body - "Trunk back Panel")4.Loosen the mounting screw and then remove the rear view camera (A).Installation1.

    Categories

     
    Copyright © 2025 www.helantra7.com - 0.013