Hyundai Elantra: Brake System / Disc Brakes Wear Indicator

Hyundai Elantra (CN7) 2021-2025 Owner's Manual / Driving your vehicle / Brake System / Disc Brakes Wear Indicator

When your brake pads are worn and new pads are required, you will hear a high pitched warning sound from your front or rear brakes. You may hear this sound come and go or it may occur whenever you depress the brake pedal.

Note that some driving conditions or climates may cause a brake squeal when you first apply (or lightly apply) the brakes. This is normal and does not indicate a problem with your brakes.

NOTICE

To avoid costly brake repairs, do not continue to drive with worn brake pads.

Information

Always replace brake pads as complete front or rear axle sets.

Brake System

Power Brakes Your vehicle has power-assisted brakes that adjust automatically through normal usage. If the engine is not running or is turned off while driving, the power assist for the brakes will not work...

Parking brake

Applying the parking brake Always set the parking brake before leaving the vehicle, to apply: Firmly depress the brake pedal. Pull up the parking brake lever as far as possible...

Other information:

Hyundai Elantra (CN7) 2021-2025 Service Manual: Brake Line

Components and components location Components Repair procedures RemovalBrake Tube [Engine Room]1.Disconnect the brake fiuid level switch connector, and remove the reservoir cap.2.Remove the brake fluid from the master cylinder reservior with a syringe...

Hyundai Elantra (CN7) 2021-2025 Service Manual: General safety information and caution

PrecautionsGeneral PrecautionsPlease read the following precautions carefully before performing the airbag system service. Observe the instructions described in this manual, or the airbags could accidentally deploy and cause damage or injuries.• When performing electrical inspections, always turn the ignition switch OFF and disconnect the negative cable from the battery, and ..

Manual climate control system

To defog inside windshield

[A] : Type A, [B] : Type B

1. Select any fan speed except “0” position.

2. Select the desired temperature.

3. Select the or position.