Hyundai Elantra Owners and Service Manuals

Hyundai Elantra: Convenient Features / Interior Lights

WARNING

Do not use the interior lights when driving in the dark. The interior lights may obscure your view and cause an accident.

NOTICE

Do not use the interior lights for extended periods when the vehicle is turned off or the battery will discharge.

Interior lamp AUTO cut

The interior lamps will automatically go off approximately 20 minutes after the engine is turned off and the doors are closed. If a door is opened, the lamp will go off 40 minutes after the engine is turned off. If the doors are locked by the remote key or smart key and the vehicle enters the armed stage of the theft alarm system, the lamps will go off five seconds later.

Function malfunction and limitations

Function malfunction When High Beam Assist is not working properly, the ‘Check High Beam Assist (HBA) system’ or ‘Check HBA (High Beam Assist) system’ warning message will appear and warning light will illuminate on the cluster...

Front lamps

(1) Front Map Lamp (2) Front Door Lamp (3) Front Room Lamp ON (4) Front Room Lamp OFF Front map lamp: Press either of these lens to turn the map lamp on or off...

Other information:

Hyundai Elantra (CN7) 2021-2024 Service Manual: Tire


Repair procedures Tire Wear1.Measure the tread depth of the tires. Tread depth [limit] : 1.6 mm (0.0630 in.)2.If the remaining tread depth (A) is less than the limit, replace the tire.    • When the tread depth of the tires is less than 1...

Hyundai Elantra (CN7) 2021-2024 Service Manual: Crankshaft Position Sensor (CKPS)


Description and operation DescriptionCrankshaft Position Sensor (CKPS) detects the crankshaft position and is one of the most important sensors of the engine control system. If there is no CKPS signal input, fuel is not supplied.That is, vehicle can't run without CKPS signal...

Categories

Tire Rotation

To equalize tread wear, HYUNDAI recommends that the tires be rotated according to the maintenance schedule or sooner if irregular wear develops.

During rotation, check the tires for correct balance.

When rotating tires, check for uneven wear and damage. Abnormal wear is usually caused by incorrect tire pressure, improper wheel alignment, out-ofbalance wheels, severe braking or severe cornering. Look for bumps or bulges in the tread or side of the tire. Replace the tire if you find any of these conditions. Replace the tire if fabric or cord is visible. After rotation, be sure to bring the front and rear tire pressures to specification and check lug nut tightness (proper torque is 79~94 lbf·ft [11~13 kgf·m]).

read more

Copyright © 2024 www.helantra7.com