Hyundai Elantra Owners and Service Manuals

Hyundai Elantra: Warning and Indicator Lights / Low Fuel Level Warning Light

This warning light illuminates:

When the fuel tank is nearly empty. Add fuel as soon as possible.

NOTICE

Driving with the Low Fuel Level warning light on or with the fuel level below "E" can cause the engine to misfire and damage the catalytic converter.

    Engine Oil Pressure Warning Light

    This warning light illuminates: When the engine oil pressure is low. If the engine oil pressure is low: 1. Drive carefully to the nearest safe location and stop your vehicle...

    Master Warning Light

    This indicator light illuminates: When there is a malfunction in operation in any of the following systems: -- Forward Collision-Avoidance Assist system malfunction (if equipped) -- Forward Collision-Avoidance Assist radar blocked (if equipped) -- Blind-Spot Collision Warning system malfunction (if equipped) -- Blind-Spot Collision Warning radar blocked (if equipped) -- High Beam Assist ..

    Other information:

    Hyundai Elantra (CN7) 2021-2025 Owner's Manual: Welcome system


    Door handle lamp When all the doors (and trunk) are closed and locked, the door handle lamp will come on for about 15 seconds if any of the below is performed. When the door unlock button is pressed on the remote key or smart key. When the button of the outside door handle is pressed. When the vehicle is approached with the smart key in possession. Headlamp and parking lamp When t..

    Hyundai Elantra (CN7) 2021-2025 Service Manual: Front Door Inside Handle


    Repair procedures Removal1.Remove the front door trim.(Refer to Front Door - "Front Door Trim")2.Cut the heat-welded part with a knife and loosen the mounting screw (B).3.Remove the front door inside handle (A).    • Be careful of breakage and cut the heat-welded part with a knife.Installation1.Install the front door inside handle.2.A screw is attached to..

    Categories

    Tire Rotation

    To equalize tread wear, HYUNDAI recommends that the tires be rotated according to the maintenance schedule or sooner if irregular wear develops.

    During rotation, check the tires for correct balance.

    When rotating tires, check for uneven wear and damage. Abnormal wear is usually caused by incorrect tire pressure, improper wheel alignment, out-ofbalance wheels, severe braking or severe cornering. Look for bumps or bulges in the tread or side of the tire. Replace the tire if you find any of these conditions. Replace the tire if fabric or cord is visible. After rotation, be sure to bring the front and rear tire pressures to specification and check lug nut tightness (proper torque is 79~94 lbf·ft [11~13 kgf·m]).

    read more

    Copyright © 2025 www.helantra7.com