Hyundai Elantra: Instrument Cluster / Warning and Indicator Lights
Information
Make sure that all warning lights are OFF after starting the engine. If any light is still ON, this indicates a situation that needs attention.
- Air Bag Warning Light & Seat Belt Warning Light
- Anti-lock Brake System (ABS) Warning Light
- Electronic Brake Force Distribution (EBD) System Warning Light
- Electronic Parking Brake (EPB) Warning Light
- AUTO HOLD Indicator Light
- Electric Power Steering (EPS) Warning Light
- Malfunction Indicator Lamp (MIL)
- Charging System Warning Light
- Engine Oil Pressure Warning Light
- Low Fuel Level Warning Light
- Master Warning Light
- Low Tire Pressure Warning Light
- Electronic Stability Control (ESC) Indicator Light
- Electronic Stability Control (ESC) OFF Indicator Light
- Immobilizer Indicator Light (with smart key)
- Turn Signal Indicator Light
- Exterior Light Warning Light
- LED headlight warning light
- High Beam Indicator Light
- Light ON Indicator Light
- High Beam Assist indicator light
- Forward Collision-Avoidance Assist Warning Light
- Lane Keep Assist Indicator Light
Air Bag Warning Light & Seat Belt Warning Light
Air Bag Warning Light
This warning light illuminates:
• When you place the ignition switch to
the ON position.
-- The air bag warning light illuminates
for about 6 seconds and then turns
off when all checks have been
performed
• The air bag warning light will remain
illuminated if there is a malfunction
with the Safety Restraint System (SRS)
air bag operation...
Other information:
Hyundai Elantra (CN7) 2021-2025 Service Manual: MDPS Wiring
Repair procedures Removal • For DTC C125901 / C125929 / C125938 / C129002, refer to "CN7 MDPS DTC Diagnostic Guide".1.Turn the ignition switch OFF and disconnect the battery negative (-) cable. • Disconnect the battery negative cable from the battery and then wait for at least 3 minutes...
Hyundai Elantra (CN7) 2021-2025 Service Manual: Clutch Tube
Components and components location Components and Components Location[Gasoline 1.6 MPI / Gasoline 2.0 MPI]1. Clutch pedal arm2. Clutch pedal assembly3. Reservoir hose4. Regulator5. Cluch tube6. Clutch hose[Gasoline 1.6 T-GDI]1. Clutch pedal arm2. Clutch pedal assembly3...
Categories
- Manuals Home
- 7th Gen Hyundai Elantra Owners Manual
- 7nd Gen Hyundai Elantra Service Manual
- Instrument Cluster Control
- Tires and Wheels
- Engine Compartment
- Function settings
- Exterior Overview
Tire Rotation
To equalize tread wear, HYUNDAI recommends that the tires be rotated according to the maintenance schedule or sooner if irregular wear develops.
During rotation, check the tires for correct balance.
When rotating tires, check for uneven wear and damage. Abnormal wear is usually caused by incorrect tire pressure, improper wheel alignment, out-ofbalance wheels, severe braking or severe cornering. Look for bumps or bulges in the tread or side of the tire. Replace the tire if you find any of these conditions. Replace the tire if fabric or cord is visible. After rotation, be sure to bring the front and rear tire pressures to specification and check lug nut tightness (proper torque is 79~94 lbf·ft [11~13 kgf·m]).
