
This indicator light blinks:
When you operate the turn signal indicator stalk.
If any of the following occur, there may be a malfunction with the turn signal system.
-- The turn signal indicator light
illuminates but does not blink
-- The turn signal indicator light blinks
rapidly
-- The turn signal indicator light does not
illuminate at all
If any of these conditions occur, have your vehicle inspected by an authorized HYUNDAI dealer.
This indicator light illuminates for up to 30 seconds: When the vehicle detects the smart key in the vehicle with the Engine Start/Stop button in the ACC or ON position.
This warning light illuminates: • When one of the exterior bulbs (headlamp, DRL, turn signal lamp, stop lamp, etc) is not operating properly. One of the bulbs may need to be replaced.
Repair procedures Removal1.Disconnect the negative (-) battery terminal.2.Remove the crash pad lower panel.(Refer to Body - "Crash Pad Lower Panel")3.Remove the steering column shroud panel.(Refer to Body - "Steering Column Shroud Panel")4.Disconnect the immobilizer connector (A) and press the locking pin (B) using an awl.
Components and components location Component Location1. Heater unit assemblyCompoents1. Heater unit assembly2. Heater tube cover3. Heater core assembly4. Mode control actuator [LH]5. Dummy PTC6. Temperature control actuator [LH]7. Heater case [LH]8.