
This indicator light illuminates for up to 30 seconds:
When the vehicle detects the smart key in the vehicle with the Engine Start/Stop button in the ACC or ON position.
-- Once the smart key is detected, you
can start the engine.
-- The indicator light goes off after
starting the engine.
This indicator light blinks for a few seconds: When the smart key is not in the vehicle.
-- If the smart key is not detected, you cannot start the engine.
This indicator light illuminates for 2 seconds and goes off:
If the smart key is in the vehicle and the Engine Start/Stop button is ON, but the vehicle cannot detect the smart key.
In this case, have the vehicle inspected by an authorized HYUNDAI dealer. This indicator light blinks:
When there is a malfunction with the immobilizer system.
In this case, have the vehicle inspected by an authorized HYUNDAI dealer.
This indicator light illuminates: • When you place the ignition switch to the ON position. -- It illuminates for approximately 3 seconds and then goes off.
This indicator light blinks: When you operate the turn signal indicator stalk. If any of the following occur, there may be a malfunction with the turn signal system.
Components and components location Components[This illustration shows the LHD type. RHD type is symmetrical.][Connector A] Pin No Function Pin No Function 1Low (Register specifications)4Middle Low (Register specifications)2Common (Register
Schematic diagrams Circuit DiagramTRIP / SCC / LFA Repair procedures Inspection1.Check for resistance between terminals in each switch position (LH).[LH : Audio + Hands free] Switch Resistance (±5%) SEEK Up430 ΩSEEK Down1.