Hyundai Elantra (CN7): Warning and Indicator Lights / High Beam Indicator Light
This indicator light illuminates:
- When the headlights are on and in the high beam position.
- When the turn signal lever is pulled into the Flash-to-Pass position.
This warning light illuminates: • When you set the Engine Start/Stop button to the ON position. -- The LED headlight warning light illuminates for approximately 3 seconds and then goes off.
This indicator light illuminates: When the tail lights or headlamps are on.
Other information:
Hyundai Elantra (CN7) 2021-2026 Service Manual: High Mounted Stop Lamp
Repair procedures Removal1.Disconnect the negative (-) battery terminal.2.Remove the rear package tray trim.(Refer to Body - "Rear Package Tray Trim")3.Loosen the mounting screws and remove the high mounted stop lamp (A).Installation1.Install the high mounted stop lamp.
Hyundai Elantra (CN7) 2021-2026 Service Manual: Ignition Switch Assembly. Repair procedures
Repair procedures Replacement1.Disconnect the negative (-) battery terminal.2.Remove the crash pad lower panel.(Refer to Body - "Crash Pad")3.Remove the steering column upper & Lower shroud.4.Remove the ignition switch and disconnecting the Key Warning / immobilizer connector.
Categories
- Manuals Home
- Hyundai Elantra Owners Manual
- Hyundai Elantra Service Manual
- Instrument Cluster
- Vehicle Information
- Body (Interior and Exterior)
- New on site
- Most important about car
