Hyundai Elantra: Warning and Indicator Lights / Light ON Indicator Light
This indicator light illuminates:
When the tail lights or headlamps are on.
High Beam Indicator Light
This indicator light illuminates:
When the headlights are on and in the
high beam position.
When the turn signal lever is pulled
into the Flash-to-Pass position...
High Beam Assist indicator
light
This indicator light illuminates:
When the High Beam is on with the
light switch in the AUTO light position.
If your vehicle detects oncoming or
preceding vehicles, High Beam Assist
system will switch the high beam to
low beam automatically...
Other information:
Hyundai Elantra (CN7) 2021-2025 Service Manual: Brake Pad
Repair procedures Replacement[Front]1.Loosen the wheel nuts slightly.Raise the vehicle, and make sure it is securely supported.2.Remove the front wheel and tire (A) from the front hub. • Be careful not to damage the hub bolts when removing the front wheel and tire (A)...
Hyundai Elantra (CN7) 2021-2025 Service Manual: Fuel Pump
Repair procedures Inspection[Fuel Pump]1.Turn ignition switch OFF and disconnect the negative (-) battery cable.2.Remove the fuel pump assembly.3.Check motor operation by fuel pump connector (A) connecting power (No.4) and ground (No.5). Pin No Discription 1Fuel sender ground2-3Fuel sender signal4Fuel pump (+)5Fuel pump (-)[Fuel S..
Categories
- Manuals Home
- 7th Gen Hyundai Elantra Owners Manual
- 7nd Gen Hyundai Elantra Service Manual
- Exterior Overview
- Engine Compartment
- Function settings
- System disabled
- Forward Collision–Avoidance Assist (FCA) (sensor fusion)
Tire Rotation
To equalize tread wear, HYUNDAI recommends that the tires be rotated according to the maintenance schedule or sooner if irregular wear develops.
During rotation, check the tires for correct balance.
When rotating tires, check for uneven wear and damage. Abnormal wear is usually caused by incorrect tire pressure, improper wheel alignment, out-ofbalance wheels, severe braking or severe cornering. Look for bumps or bulges in the tread or side of the tire. Replace the tire if you find any of these conditions. Replace the tire if fabric or cord is visible. After rotation, be sure to bring the front and rear tire pressures to specification and check lug nut tightness (proper torque is 79~94 lbf·ft [11~13 kgf·m]).
