Hyundai Elantra (CN7): Manual Transaxle System / Manual Transaxle System
Special Service Tools Tools (Number and name) Illustration Use Engine support fixture (Beam)09200-3N000Removal and installation of the transaxle.
General information General Information1.Check & Change intervals Check & Replenishment Change Capacity Oil specification Normal use Severe Use 60,000 km / 4 years(40,000 miles / 4years)No service required120,000 km(80,000 miles)1.
Other information:
Hyundai Elantra (CN7) 2021-2026 Service Manual: High Mounted Stop Lamp
Repair procedures Removal1.Disconnect the negative (-) battery terminal.2.Remove the rear package tray trim.(Refer to Body - "Rear Package Tray Trim")3.Loosen the mounting screws and remove the high mounted stop lamp (A).Installation1.Install the high mounted stop lamp.
Hyundai Elantra (CN7) 2021-2026 Service Manual: Temperature Control Actuator
Description and operation DescriptionThe temperature control actuator is located at the heater unit. It regulates the temperature by the procedure as follows. The signal from the control unit adjusts the position of the temperature door by operating the temperature switch.
Categories
- Manuals Home
- Hyundai Elantra Owners Manual
- Hyundai Elantra Service Manual
- General Tightening Torque Table. General information
- Clutch System
- Vehicle Information
- New on site
- Most important about car
