Hyundai Elantra (CN7): Manual Transaxle System / Special service tools

Hyundai Elantra (CN7) 2021-2026 Service Manual / Manual Transaxle System / Special service tools

Special Service Tools
Tools
(Number and name)
Illustration
Use
Engine support fixture (Beam)
09200-3N000

Removal and installation of the transaxle.
Used with the supporter (09200-2S100).
Engine support fixture (Rear)
09200-L1100

Removal and installation of the transaxle.with the beam (SST No. : 09200-38001/3N000).
Engine support fixture (Front)
09200-L1200

Removal and installation of the transaxle.with the beam (SST No. : 09200-38001/3N000)
Engine support fixture (Adapter)
09200-4X000

Removal and installation of the transaxle.
Use this beam (SST No. : 09200-3N000)
Oil seal installer
09453-2F300

Used for installing differential oil seal

    Specifications Manual transaxle type FF 6th Manual Transaxle (M6CF3-1) Engine typeGasoline 1.6 T-GDIGear ratio1st3.

    Other information:

    Hyundai Elantra (CN7) 2021-2026 Service Manual: Ignition Switch Assembly. Repair procedures

    Repair procedures Replacement1.Disconnect the negative (-) battery terminal.2.Remove the crash pad lower panel.(Refer to Body - "Crash Pad")3.Remove the steering column upper & Lower shroud.4.Remove the ignition switch and disconnecting the Key Warning / immobilizer connector.

    Hyundai Elantra (CN7) 2021-2026 Service Manual: Blower Resistor (Manual)

    Repair procedures Inspection1.Measure the resistance between the terminals.2.The measured resistance is not within specification, the blower resistor must be replaced. (After removing the resistor)Replacement1.Disconnect the negative (-) battery terminal.

    Categories

     
    Copyright В© 2026 www.helantra7.com - 0.0154