Hyundai Elantra (CN7): Manual Transaxle System / Specifications

Specifications
Manual transaxle type
FF 6th Manual Transaxle (M6CF3-1)
Engine type
Gasoline 1.6 T-GDI
Gear ratio
1st
3.308
2nd
1.962
3rd
1.294
4th
0.976
5th
0.778
6th
0.633
Reverse
3.583
Final gear ratio
4.467

Tightening Torques
Items
N.m
kgf.m
lb-ft
Oil drain plug 
58.9 - 78.5
6.0 - 8.0
43.4 - 57.8
Oil filler plug 
58.9 - 78.5
6.0 - 8.0
43.4 - 57.8
Shift lever assembly mounting bolt
8.8 - 13.7
0.9 - 1.4
6.5 - 10.1
Roll rod bracket mounting bolt
107.9 - 127.5
11.0 - 13.0
79.6 - 94.1
49.0 - 63.7
5.0 - 6.5
36.2 - 47.0
Roll rod support bracket bolt
49.0 - 68.6
5.0 - 7.0
36.2 - 50.6
Control cable retainer mounting nut
11.8 - 14.7
1.2 - 1.5
8.7 - 10.8
Back up lamp switch
39.2 - 58.8
4.0 - 6.0
28.9 - 43.4
Control shaft assembly mounting bolt
19.6 - 26.5
2.0 - 2.7
14.5 - 19.5
Control cable bracket mounting bolt
14.7 - 21.6
1.5 - 2.2
10.8 - 15.9
Transaxle bracket mounting bolt
58.9 - 78.5
6.0 - 8.0
43.4 - 57.8
Transaxle bracket support mounting bolt
88.3 - 107.9
9.0 - 11.0
65.1 - 79.6
Starter mounting bolt 
49.0 - 63.7
5.0 - 6.5
36.2 - 47.0
Transaxle upper mounting bolt (TM=>ENG)
42.2 - 53.9
4.3 - 5.5
31.1 - 39.8
Transaxle lower mounting bolt (ENG=>TM)
42.2 - 48.1
4.3 - 4.9
31.1 - 35.4
42.2 - 53.9
4.3 - 5.5
31.1 - 39.8

Lubricant
Item
Recommended
Capacity
Manual transaxle oil
API GL-4, SAE 70W, TGO-9 (MS517-14)
• Recommended oil
–
SHELL : SPIRAX S6 GHME 70W MTF
–
SK : HK SYN MTF 70W
–
GS CALTEX : GS MTF HD 70W
1.5 - 1.6 L
(0.39 - 0.42 U.S.gal., 1.59 - 1.69 U.S.qt., 1.32 - 1.40 lmp qt.)

Sealant
Items
Specified sealant
Capacity
Control shaft assembly
LOCTITE 5060 or equivalent
As required

    Troubleshooting Symptom Suspected Area Remedy  Abnormal noiseOil level (Low)To adding oil after inspect the parts (Oil seal, Drain plug, filler plug).

    Special Service Tools Tools (Number and name) Illustration Use Engine support fixture (Beam)09200-3N000Removal and installation of the transaxle.

    Other information:

    Hyundai Elantra (CN7) 2021-2026 Service Manual: Blower Unit

    Components and components location Component Location1. Blower unit assemblyComponents1. Blower unit assebmly2. Blower upper cover [LH]3. Duct seal4. Blower upper cover [RH]5. Intake actuator6. Air filter cover7. Intake door8. Air filter9. Blower upper case10.

    Hyundai Elantra (CN7) 2021-2026 Service Manual: Blower Resistor (Manual)

    Repair procedures Inspection1.Measure the resistance between the terminals.2.The measured resistance is not within specification, the blower resistor must be replaced. (After removing the resistor)Replacement1.Disconnect the negative (-) battery terminal.

    Categories

     
    Copyright © 2026 www.helantra7.com - 0.0154