Hyundai Elantra (CN7): Manual Transaxle System
- Troubleshooting
- Specifications
- Special service tools
- Manual Transaxle System
- Manual Transaxle Control System
Repair procedures Removal1.Remove the manual transaxle assembly. (Refer to Manual Transaxle System - "Manual Transaxle")2.Loosen the bolts and then removing the concentric slave cylinder assembly (A) from the clutch housing.
Troubleshooting Symptom Suspected Area Remedy Abnormal noiseOil level (Low)To adding oil after inspect the parts (Oil seal, Drain plug, filler plug).
Other information:
Hyundai Elantra (CN7) 2021-2026 Service Manual: Receiver-Drier
Repair procedures Replacement1.Remove the condenser.2.Remove the cap (A) on the bottom of the condenser with a L wrench. Tightening torque : 9.81 - 14.71 N.m (1.0 - 1.5 kgf.m, 7.2 - 10.8 lb-ft) 3.Remove the receiver-drier (A) from condenser using a long nose plier.
Hyundai Elantra (CN7) 2021-2026 Service Manual: PM Sensor
Description and operation DiscriptionMonitor the air quality inside the vehicle in real time (PM sensor) and display the status on the screen.Automatically operate when fine dust concentration is high (Condition: Bet mode + A/C ON + 3rd speed or higher) Components and components location Components Location1.
Categories
- Manuals Home
- Hyundai Elantra Owners Manual
- Hyundai Elantra Service Manual
- General Tightening Torque Table. General information
- Driver assistance system
- Front Bumper
- New on site
- Most important about car
