Hyundai Elantra (CN7): Cowl Top Cover / Repair procedures

Hyundai Elantra (CN7) 2021-2025 Service Manual / Body (Interior and Exterior) / Cowl Top Cover / Repair procedures

Replacement
1.
Remove the plug hole (A).

2.
Loosen the mounting nuts and remove the wiper arm (A).
Tightening torque :
22.6 - 26.5 N.m (2.3 - 2.7 kgf.m, 16.6 - 19.5 lb-ft)

3.
Disconnect the washer nozzle (A).
4.
Detach the clips, then remove the cowl top cover (B).

5.
To install, reverse the removal procedure.
   
•
Replace any damaged clips (or pin - type retainers).

    Component Location 1. Cowl top cover

    Other information:

    Hyundai Elantra (CN7) 2021-2025 Service Manual: Ambient Temperature Sensor

    Description and operation DescriptionThe ambient temperature sensor is located at the front of the condenser and detects ambient air temperature. It is a negative type thermistor; resistance will increase with lower temperature, and decrease with higher temperature.

    Hyundai Elantra (CN7) 2021-2025 Service Manual: Mode Control Actuator

    Description and operation DescriptionThe mode control actuator is located at the heater unit.It adjusts the position of the mode door by operating the mode control actuator based on the signal of the A/C control unit. Pressing the mode select switch makes the mode control actuator shift in order of Vent → Bi-Level → Floor → Mix.

    Categories

     
    Copyright © 2025 www.helantra7.com - 0.0131