Hyundai Elantra (CN7): Restraint
- General safety information and caution
- Description and operation
- Specifications
- Special service tools
- Repair procedures
- SRSCM
- Components and components location
- SRS Control Module (SRSCM)
- Front Impact Sensor (FIS)
- Side Impact Sensor (SIS)
- Seat Belt Buckle Switch (BS)
- Occupant Classification System(OCS)
- Airbag Module
- Driver Airbag (DAB) Module and Clock Spring
- Passenger Airbag (PAB) Module
- Side Airbag (SAB) Module
- Curtain Airbag (CAB) Module
- Airbag Module Disposal
- Seat Belt Pretensioner. Seat Belt Pretensioner (BPT)
Repair procedures Removal • For DTC C125901 / C125929 / C125938 / C129002, refer to "CN7 MDPS DTC Diagnostic Guide".
PrecautionsGeneral PrecautionsPlease read the following precautions carefully before performing the airbag system service. Observe the instructions described in this manual, or the airbags could accidentally deploy and cause damage or injuries.
Other information:
Hyundai Elantra (CN7) 2021-2026 Service Manual: Refrigerant Line
Components and components location Components Location1. Refrigerant Pipe Assembly Repair procedures Replacement1.If the compressor is marginally operable, run the engine at idle speed, and let the air conditioning work for a few minutes, then shut the engine off.
Hyundai Elantra (CN7) 2021-2026 Service Manual: Mode Control Actuator
Description and operation DescriptionThe mode control actuator is located at the heater unit.It adjusts the position of the mode door by operating the mode control actuator based on the signal of the A/C control unit. Pressing the mode select switch makes the mode control actuator shift in order of Vent → Bi-Level → Floor → Mix.
Categories
- Manuals Home
- Hyundai Elantra Owners Manual
- Hyundai Elantra Service Manual
- Rear Seats
- Brake bleeding procedures
- Drive Mode
- New on site
- Most important about car
