Hyundai Elantra (CN7): Restraint / Repair procedures

Hyundai Elantra (CN7) 2021-2026 Service Manual / Restraint / Repair procedures

Component Replacement after Deployment
   
•
Before doing any SRS repairs, use the diagnostic tool to check for DTCs. refer to the diagnostic Trouble Code list for repairing of the related DTCs.
When the front airbag(s) deployed after a collision, replace the following items.
–
SRSCM
–
Deployed airbag
–
Lighted seat belt pretensioner
–
Lighted anchor pretensioner
–
Front impact sensors
–
Airbag wiring harnesses
–
Inspect the clock spring for heat damage.
If any damage found, replace the clock spring.
When the side/curtain airbag deployed after a collision, replace the following items.
–
SRSCM
–
Deployed airbag
–
Side impact sensor for the deployed side
–
Airbag wiring harnesses
–
Lighted seat belt pretensioner
–
Lighted anchor pretensioner
After the vehicle is completely repaired, confirm the SRS airbag system is OK.
–
Turn the ignition switch ON; the SRS indicator should come on for about six seconds and then go off.

    Special Service Tools Tool (Number and Name) Illustration Use Deployment tool 0957A-34100AAirbag deployment tool.

    Other information:

    Hyundai Elantra (CN7) 2021-2026 Service Manual: Rear Combination Lamp

    Repair procedures RemovalOutside Combination Lamp1.Disconnect the negative (-) battery terminal.2.Remove the combination lamp cover (A).3.Disconnect the rear combination lamp connector (A).4.Loosen the mounting nuts and remove the rear conbination lamp (A).

    Hyundai Elantra (CN7) 2021-2026 Service Manual: Photo Sensor

    Description and operation Description 1.The photo sensor is located at the center of the defrost nozzles.2.The photo sensor contains a photovoltaic (sensitive to sunlight) diode. The solar radiation received by its light receiving portion, generates an electromotive force in proportion to the amount of radiation received which is transferred to

    Categories

     
    Copyright © 2026 www.helantra7.com - 0.02