Hyundai Elantra (CN7): Clutch System / Clutch System
- Clutch Cover And Disc
- Ignition Lock & Clutch Switch
- Clutch Pedal
- Regulator
- Clutch Tube
- Clutch Master Cylinder
- Concentric Slave Cylinder Assembly
Special Service Tools Tool (Number and name) Illustration Use 09411-1P000Clutch disc guideInstallation of the clutch disc.
Repair procedures Removal1.Remove the manual transaxle assembly.(Refer to Manual Transaxle System - "Manual Transaxle")2. Remove the clutch cover assembly after loosening the bolts.
Other information:
Hyundai Elantra (CN7) 2021-2026 Service Manual: Blower Resistor (Manual)
Repair procedures Inspection1.Measure the resistance between the terminals.2.The measured resistance is not within specification, the blower resistor must be replaced. (After removing the resistor)Replacement1.Disconnect the negative (-) battery terminal.
Hyundai Elantra (CN7) 2021-2026 Service Manual: Intake Actuator
Description and operation DescriptionThe intake actuator is located at the blower unit. It regulates the intake door by a signal from the control unit. Pressing the intake selection switch will shift between recirculation and fresh air modes. Components and components location Components Location1.
Categories
- Manuals Home
- Hyundai Elantra Owners Manual
- Hyundai Elantra Service Manual
- General Tightening Torque Table. General information
- Drive Mode
- Rear Seats
- New on site
- Most important about car
