Hyundai Elantra (CN7): Front Door / Front Door Module

Hyundai Elantra (CN7) 2021-2026 Service Manual / Body (Interior and Exterior) / Front Door / Front Door Module

Components and components location

Component Location

1. Front door module


Repair procedures

Replacement
1.
Remove the front door window glass.
(Refer to Front Door - "Front Door Window Glass")
2.
Remove the front door outside handle.
(Refer to Front Door - "Front Door Outside Handle")
3.
Remove the outside handle pad (A).

4.
Loosen the front door outside handle base mounting bolt (A).
Tightening torque :
3.9 - 5.9 N.m (0.4 - 0.6 kgf.m, 2.9 - 4.3 lb-ft)

5.
Press the lock pin, separate the outside rear view mirror connector (A).

6.
Press the lock pin, sepatate the front door main connector (A).

7.
Loosen the front door latch mounting screws and bolts.
Screw : 9.8 - 14.7 N.m (1.0 - 1.5 kgf.m, 7.2 - 10.8 lb-ft)
Bolt : 8.8 - 13.7 N.m (0.9 - 1.4 kgf.m, 8.5 - 10.1 lb-ft)

8.
Loosen the mounting bolts and remove the front door module (A).
Tightening torque :
7.8 - 11.8 N.m (0.8 - 1.2 kgf.m, 5.8 - 8.7 lb-ft)

9.
To install, reverse the removal procedure.
   
•
Make sure connectors are connected properly and each rod is connected securely.
•
Make sure the door locks / unlocks and opens / closes properly.

    Components and components location Component Location 1. Front door window glass Repair procedures Replacement1.Remove the front door trim.

    Components and components location Component Location 1. Front door outside handle Repair procedures Replacement1.Remove the plug hole (A).

    Other information:

    Hyundai Elantra (CN7) 2021-2026 Service Manual: Compressor oil

    Repair procedures Oil Specification1.The HFC-134a system requires synthetic (PAG) compressor oil whereas the R-12 system requires mineral compressor oil. The two oils must never be mixed.2.Compressor (PAG) oil varies according to compressor model. Be sure to use oil specified for the model of compressor.

    Hyundai Elantra (CN7) 2021-2026 Service Manual: Ambient Temperature Sensor

    Description and operation DescriptionThe ambient temperature sensor is located at the front of the condenser and detects ambient air temperature. It is a negative type thermistor; resistance will increase with lower temperature, and decrease with higher temperature.

    Categories

     
    Copyright © 2026 www.helantra7.com - 0.0259