Hyundai Elantra (CN7): Interior Trim / Luggage Side Trim

Hyundai Elantra (CN7) 2021-2026 Service Manual / Body (Interior and Exterior) / Interior Trim / Luggage Side Trim

Components and components location

Component Location

1. Luggage side trim

Repair procedures

Replacement

•	When removing with a flat - tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.

•	Put on gloves to prevent hand injuries.

•	Take care not to bend or scratch the trim and panels.

1.	Detach the clips, then remove the front door body side weatherstrip (A). [LH] [RH]

2.	Remove the rear seat assembly (Refer to Rear Seat - "Rear Seat Assembly")

3.	Loosen the mounting screws and remove the rear door scuff trim (A).

4.	Remove the luggage boad (A).

5.	Loosen the mounting clips and remove the rear transverse trim (A).

6.	Loosen mounting clips and bolts, remove the luggage partition side trim (A) and (B).

7.	After loosening the mounting bolts and screws, remove the luggage side trim (A).

To install, reverse the removal procedure.

•	Replace any damaged clips (or pin - type retainers).

❮Rear Transverse Trim

Components and components location Component Location 1. Rear transverse trim Repair procedures Replacement • When removing with a flat - tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.

Windshield Glass❯

Other information:

Hyundai Elantra (CN7) 2021-2026 Service Manual: Temperature Control Actuator

Description and operation DescriptionThe temperature control actuator is located at the heater unit. It regulates the temperature by the procedure as follows. The signal from the control unit adjusts the position of the temperature door by operating the temperature switch.

Hyundai Elantra (CN7) 2021-2026 Service Manual: Repair procedures