Hyundai Elantra (CN7): Engine Control System / Manifold Absolute Pressure Sensor (MAPS)
Description and operation
Manifold Absolute Pressure Sensor (MAPS) is a speed-density type sensor and is installed on the surge tank. It senses absolute pressure of the surge tank and transfers the analog signal proportional to the pressure to the ECM. By using this signal, the ECM calculates the intake air quantity and engine speed.
The MAPS consists of a piezo-electric element and a hybrid IC amplifying the element output signal. The element is silicon diaphragm type and adapts pressure sensitive variable resistor effect of semi-conductor. Because 100% vacuum and the manifold pressure apply to both sides of the sensor respectively, this sensor can output analog signal by using the silicon variation proportional to pressure change.
Specifications
Pressure
[kPa (kgf/cm², psi)]
|
Output Voltage (V)
[Vref = 5.0V]
|
10 (0.10, 1.45)
| 0.5
|
40 (0.40, 5.80)
| 0.91
|
80 (0.81, 11.60)
| 1.47
|
120 (1.22, 17.40)
| 2.02
|
160 (1.63, 23.20)
| 2.57
|
200 (2.03, 29.00)
| 3.12
|
220 (2.24, 31.90)
| 3.4
|
240 (2.44, 34.80)
| 3.67
|
280 (2.85, 40.61)
| 4.22
|
300 (3.05 43.51)
| 4.5
|
Schematic diagrams
Harness Connector
Repair procedures
| 1. | Connect a diagnostic tool on Data Link Connector (DLC). |
| 2. | Check MAPS output voltage at idle and IG ON.
Condition
| Output Voltage (V)
| IG ON
| 3.9 - 4.1
| Idle
| 0.8 - 1.6
|
|
| 1. | Turn ignition switch OFF and disconnect the battery negative (-) terminal. |
| 2. | Disconnect the manifold absolute pressure sensor connector (A). |
| 3. | Remove the manifold absolute pressure sensor (B) after loosening the bolt. Tightening Torque : 9.8 - 11.8 N.m (1.0 - 1.2 kgf.m, 7.2 - 8.7 lb-ft) |
|
| •
| Install the component with the specified torques. |
| •
| Note that internal damage may occur when the component is dropped. In this case, use it after inspecting. |
|
| •
| Insert the sensor in the installation hole and be careful not to damage when installation. |
|
| 1. | Install in the reverse order of removal. |
Description and operation
DescriptionThe Electronic Throttle Control (ETC) System consists of a throttle body with an integrated control motor and throttle position sensor (TPS).
Description and operation
DescriptionIntake Air Temperature Sensor (IATS) is included inside Manifold Absolute Pressure Sensor and detects the intake air temperature.
Other information:
Components and components location
Component
Repair procedures
Removal1.Disconnect the negative(-) battery terminal.2.Remove the AVN Head unit.(Refer to Body Electrical System - "AVN(Audio Video Navigation) head unit")3.Loosen the mounting screws and remove the start/stop button (A).
Instructions (R-134a)When Handling Refrigerant1.R-134a liquid refrigerant is highly volatile. A drop on the skin of your hand could result in localized frostbite. When handling the refrigerant, be sure to wear gloves. 2.It is standard practice to wear goggles or glasses to protect your eyes, and gloves to protect your hands.
