Hyundai Elantra (CN7): Body (Interior and Exterior) / Special service tools
| Special Service Tools |
|
Tool (Number and name)
|
Illustration
|
Use
|
| 09880 - 4F000 Hog ring clip installer |
| Hog ring clip installation |
Specifications Items Specification HoodTypeFront openine type, rear hinged, stay rod typeFront DoorConstructionFront hinged, frame door constructionRegulator systemWire drum typeLocking systemPin - fork systemRear DoorConstructionFront hinged, frame door constructionRegulator systemWire drum typeLocking systemPin - fork systemTrunk LidTypeTorsior bay typeSeat BeltsFront3 point type with Emergency Locking Retractor (E.
Components and components location Component Location1. Fender assembly Repair procedures Replacement • When removing the fender, wrap protective tape around a screwdriver or remover not to damage components• Put on gloves to prevent hand injuries1.
Other information:
Hyundai Elantra (CN7) 2021-2026 Service Manual: Compressor
Description and operation DescriptionThe compressor is the power unit of the A/C system.It is located on the side of engine block and driven by a V-belt of the engine.The compressor changes low pressure and low temperature refrigerant gas into high pressure and high temperature refrigerant gas.
Hyundai Elantra (CN7) 2021-2026 Service Manual: Mode Control Actuator
Description and operation DescriptionThe mode control actuator is located at the heater unit.It adjusts the position of the mode door by operating the mode control actuator based on the signal of the A/C control unit. Pressing the mode select switch makes the mode control actuator shift in order of Vent → Bi-Level → Floor → Mix.
Categories
- Manuals Home
- Hyundai Elantra Owners Manual
- Hyundai Elantra Service Manual
- Engine Control / Fuel System
- Drive Mode
- Instrument Cluster
- New on site
- Most important about car
