| Troubleshooting |
|
Symptom
|
Passible Cause
|
Remedy (Refer to page)
|
| Water leaks from panorama sunroof | Deteriorated roof lid weatherstrip | Replace |
| Excessive roof lid - to - body clearance and improperly fitted weatherstrip | Adjust | |
| Wind noise around sunroof | Loose or deformed deflector, gaps in body work | Retighten adjust or replace |
| Noise created by moving sunroof lid | Foreign particles lodged in guide rail | Check drive cable and guide rails for foreign particles |
| Loose guide rails and lid | Retighten | |
| Motor runs but sunroof does not move or moves only partially | Foreign particles lodged in guide rail | Adjust or replace |
| Incorrect engagement of motor pinion with drive cable | ||
| Decrease in motor's clutch slipping force | ||
| Increased sunroof sliding resistance or interference of sunroof with drive cables, weatherstrip, etc. due tomal adjustment of sunroof | ||
| Noise in motor (clutch slipping noise from motor when sunroof is fully opened or closed) is considered as normal | Incorrect engagement of motor pinion with drive cable | Check pinion installation and |
| Re - tighten motor | ||
| Worn out or damaged motor pinion bearing | Replace motor assembly | |
| Worn out or deformed drive cable | Replace | |
| Door glass fails to operate up and down | Incorrect window glass installation | Adjust position |
| Damaged or faulty regulator arm or regulator | Correct or replace | |
| Door does not open or close completely | Incorrect door installation | Adjust position |
| Defective door check assembly | Correct or replace | |
| Door hinge requires grease | Apply grease | |
| Hood does not open or close completely | Striker and latch not properly aligned | Adjust |
| Incorrectly installed hood | Adjust | |
| Incorrect hood bumper height | Adjust | |
| Water leaks through windshield and rear window | Defective seal | Fill with sealant |
| Defective flange | Correct |
Specifications Items Specification HoodTypeFront openine type, rear hinged, stay rod typeFront DoorConstructionFront hinged, frame door constructionRegulator systemWire drum typeLocking systemPin - fork systemRear DoorConstructionFront hinged, frame door constructionRegulator systemWire drum typeLocking systemPin - fork systemTrunk LidTypeTorsior bay typeSeat BeltsFront3 point type with Emergency Locking Retractor (E.
Instructions (R-134a)When Handling Refrigerant1.R-134a liquid refrigerant is highly volatile. A drop on the skin of your hand could result in localized frostbite. When handling the refrigerant, be sure to wear gloves. 2.It is standard practice to wear goggles or glasses to protect your eyes, and gloves to protect your hands.
Components and components location Component Location1. Blower unit assemblyComponents1. Blower unit assebmly2. Blower upper cover [LH]3. Duct seal4. Blower upper cover [RH]5. Intake actuator6. Air filter cover7. Intake door8. Air filter9. Blower upper case10.