| Troubleshooting |
| Problem Symptoms Table |
|
Symptom
|
Suspected Area
|
| No blower operation | Blower fuse |
| Blower relay | |
| Blower motor | |
| Power mosfet | |
| Blower speed control switch | |
| Wire harness | |
| No air temperature control | Engine coolant capacity |
| Heater control assembly | |
| No compressor operation | Refrigerant capacity |
| A/C fuse | |
| Compressor | |
| A/C pressure transducer | |
| A/C switch | |
| Evaporator temperature sensor | |
| Wire harness | |
| Vented air not cold | Refrigerant capacity |
| Refrigerant pressure | |
| Drive belt | |
| Compressor | |
| A/C pressure transducer | |
| Evaporator temperature sensor | |
| A/C switch | |
| Heater control assembly | |
| Wire harness | |
| Insufficient cooling | Refrigerant capacity |
| Drive belt | |
| Compressor | |
| Condenser | |
| Expansion valve | |
| Evaporator | |
| Refrigerant lines | |
| A/C pressure transducer | |
| Heater control assembly | |
| No engine idle-up when A/C switch ON | Engine ECM |
| Wire harness | |
| No air inlet control | Heater control assembly |
| No mode control | Heater control assembly |
| Mode actuator | |
| No cooling fan operation | Cooling fan fuse |
| Fan motor | |
| Engine ECM | |
| Wire harness |
SpecificationAir Conditioner Item Specification CompressorTypeGamma 1.6 MPI, Gasoline 2.0 NU MPI, Gasoline 1.
Components and components location Component Location1. Heater control unitComponents[Connector A] Pin No Function Pin No Function 1Mode control actuator (Feedback)21Mode control actuator (Vent)2Intake actuator (Feedback)22Mode control actu
Description and operation Description• PDW consists of 8 sensors (front : 4 units, rear : 4 units) that are used to detect obstacles and transmit the result in three separate warning levels, the first, second and third to IBU via LIN communication.