Hyundai Elantra: Rear View Monitor (RVM) / Description and operation

Hyundai Elantra (CN7) 2021-2025 Service Manual / Advanced Driver Assistance System (ADAS) / Rear View Monitor (RVM) / Description and operation

Description

Rear view camera will activate when the backup light is ON with the ignition switch ON and the shift lever in the R position.

This system is a supplemental system that shows behind the vehicle through the AV monitor or the ECM (Reverse Display Room Mirror) mirror while backing-up.

This system is a supplementary function only. It is the responsibility of the driver or always check the inside/ outside rear view mirror and the area behind the vehicle before and while backing up because there is a dead zone that can't see through the camera.

Rear View Monitor (RVM)

Components and components location

Component Location1. Rear view camera2. AVN monitor..

Other information:

Hyundai Elantra (CN7) 2021-2025 Service Manual: Lumber Support Units

Repair procedures Removal1.Disconnect the negative (-) battery terminal.2.Remove the front seat assembly.(Refer to Body - "Front Seat Assembly")3.Remove the seat back.(Refer to Body - "Front Seat Back Cover")4.Disconnect the lumber support motor connector (A).5.Separate the retaining clips (A) from the seat frame.6.Remove the lumber support assembly (A) after disengaging mounting clip.Installat..

Hyundai Elantra (CN7) 2021-2025 Service Manual: Components and components location

Component Location1. Integrated body control unit (IBU) 2. Ultrasonic sensor..

Rear center seat belt

When using the rear center seat belt, the buckle with the “CENTER” mark must be used.

WARNING

Make sure that the seatback is locked in place when using the rear center seat belt.

If not, the seatback may move when there is a sudden stop or collision, which could result in serious injury.