Hyundai Elantra: Cylinder Block / Fly Wheel

Hyundai Elantra (CN7) 2021-2025 Service Manual / Engine Mechanical System / Cylinder Block / Fly Wheel

Repair procedures

Removal and Installation

1.	Remove the automatic transaxle. (Refer to Manual Transaxle System - "Manual Transaxle") (Refer to DCT (Dual Clutch Transmission) System - "Dual Clutch Transmission Assembly")

Remove the fly wheel (A).

Tightening torque :

71.5 - 75.5 N.m (7.3 - 7.7 kgf.m, 52.8 - 55.6 lb-ft)

•	Always use a new fly wheel mounting bolts.

3.	Install in the reverse order of removal.

Water Jacket Insert

Components and components location Components1. LH Water jacket insert2. RH Water jacket insert Repair procedures Removal and Installation1...

Rear Oil Seal

Components and components location Components1. Rear oil seal Repair procedures Replacement1.Remove the drive plate.(Refer to Cylinder Block - "Drive Plate")2...

Other information:

Hyundai Elantra (CN7) 2021-2025 Service Manual: Parking Brake Lever

Repair procedures Removal1.Turn ignition switch OFF and disconnect the negative (-) battery cable.2.Release the parking brake.3.Remove the floor console assembly. (Refer to Body - "Floor Console")4.Remove the floor console mounting bracket (A).5.Disconnect the parking brake switch connector (A)...

Hyundai Elantra (CN7) 2021-2025 Service Manual: Input Speed Sensor

Description and operation Description• Components location : DCT (Dual Clutch Transmission)• Function The input shaft speed sensor is important in that it detects the input shaft RPM and sends this information to the Transmission Control Module (TCM)...

Tachometer

The tachometer indicates the approximate number of engine revolutions per minute (RPM).

Use the tachometer to select the correct shift points and to prevent lugging and/ or over-revving the engine.

NOTICE

Do not operate the engine within the tachometer's RED ZONE. This may cause severe engine damage.