Hyundai Elantra: Rear View Monitor (RVM) / Function settings

Hyundai Elantra (CN7) 2021-2025 Owner's Manual / Driver assistance system / Parking Safety / Rear View Monitor (RVM) / Function settings

Camera settings

You can change Rear View Monitor settings by pressing the setup icon () on the screen while the system is operating, or select ‘Driver Assistance → Parking Safety → Camera Settings’ from the Settings menu while the Engine Start/Stop button is in the ON position.

Operating button

Parking/View button

Press the Parking/View button (1) to turn on Rear View Monitor.

Press the button again to turn off the function.

Rear View Monitor (RVM)

Rear View Monitor will show the area behind the vehicle to assist you when parking or backing up. Detecting sensor [1] : Rear view camera Refer to the picture above for the detailed location of the detecting sensor...

Function operation

Rear view Operating conditions Shift the gear to R (Reverse), the image will appear on the screen. Press the Parking/View button (1) while the gear is in P (Park), the image will appear on the screen...

Other information:

Hyundai Elantra (CN7) 2021-2025 Service Manual: Power Door Lock Switch

Repair procedures InspectionPower Door Lock Switch Inspection1.Check for continuity between the terminals. If there is an abnormality, replace the switch.Removal • Be careful not to scratch the door trim and other parts...

Hyundai Elantra (CN7) 2021-2025 Owner's Manual: Locking your vehicle (Button type)

1. Close all doors, engine hood and trunk. 2. Carry the smart key. 3. Either press the door handle button or press the Door Lock button (1) on the smart key. 4. The hazard warning lights will blink. 5. Make sure the doors are locked by pulling the door outside handle...

Tilting the sunroof

Tilt the sunroof open:

Push the sunroof control lever upward until the sunroof moves to the desired position.

To close the sunroof:

Press the sunroof lever forward until the sunroof moves to the desired position.