Hyundai Elantra: Mirror / Inside Rear View Mirror

Hyundai Elantra (CN7) 2021-2025 Service Manual / Body (Interior and Exterior) / Mirror / Inside Rear View Mirror

Components and components location

Component Location

1. Inside rear view mirror

Repair procedures

Replacement

•	When removing with a flat - tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.

•	Put on gloves to prevent hand injuries.

1.	Remove the inside rear view mirror cover (A).

2.	Using a screwdriver or remover, remove the rain sensor cover (A).

3.	Disconnect the inside rear view mirror connector (A).

4.	Loosen the mounting screw and push the inside rear view mirror base upward to remove the inside rear view mirror assembly (A).

To install, reverse the removal procedure.

•	Make sure the connector is connected properly.

•	Be careful not to damage the windshield glass.

Outside Rear View Mirror

Components and components location Component Location 1. Outside rear view mirror Repair procedures Replacement • When removing with a flat - tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components...

Cowl Top Cover

Other information:

Hyundai Elantra (CN7) 2021-2025 Owner's Manual: Function settings

Setting Blind-Spot Safety With the engine on, select or deselect ‘Driver Assistance → Blind-Spot Safety’ from the Settings menu to set whether or not to use each function. -- If ‘Active Assist’ is selected, the system will warn the driver with a warning message, an audible warning and braking assist will be applied depending on the collision risk levels. -- If ‘Warning Only’..

Hyundai Elantra (CN7) 2021-2025 Service Manual: Front Oil Seal

Repair procedures Replacement1.Remove the crankshaft damper pulley.(Refer to Drive Belt System - "Crankshaft Damper Pulley")2.Remove the front oil seal (A).3.Using the SST (0K231-2C200), install a new front oil seal. • Always use a new front oil seal.4.Install in the reverse order of removal. ..

Air bag collision sensors

1. SRS control module/Rollover sensor
2. Front impact sensors
3. Side impact sensors (acceleration)
4. Side impact sensors (pressure)