Hyundai Elantra: Body Side Molding / Rear Wheel Guard

Hyundai Elantra (CN7) 2021-2025 Service Manual / Body (Interior and Exterior) / Body Side Molding / Rear Wheel Guard

Repair procedures

Replacement

•	When removing with a flat - tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.

•	Put on gloves to prevent hand injuries.

1.	Remove the rear tire.

2.	After loosening the mounting screws, clips and nut, remove the rear wheel guard [Rear] (A).

3.	After loosening the mounting screws, clips and nut, remove the rear wheel guard [Front] (A).

To install, reverse the removal procedure.

•	Replace any damaged clips (or pin - type retainers).

Front Wheel Guard

Repair procedures Replacement • When removing with a flat - tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components...

Front Mud Guard

Repair procedures Replacement • When removing with a flat - tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components...

Other information:

Hyundai Elantra (CN7) 2021-2025 Owner's Manual: Fan speed control & Air conditioning

Fan speed control Turn the knob to the right to increase the fan speed and airflow. Turn the knob to the left to decrease fan speed and airflow. Setting the fan speed control knob to the “0” position turns off the fan. NOTICE Operating the fan speed when the ignition switch is in the ON position could cause the battery to discharge...

Hyundai Elantra (CN7) 2021-2025 Service Manual: Special service tools

Special Service Tools Tool (Number and Name) IIIustration Use 09568-1S100Ball joint removerSaperate the ball joint from the front alxe09563-IB000Small bearing removerRemove the small bearing09563-IB200Small bearing installerInstall the small bearing..

Manual climate control system

To defog inside windshield

[A] : Type A, [B] : Type B

1. Select any fan speed except “0” position.

2. Select the desired temperature.

3. Select the or position.