Hyundai Elantra: Trunk Lid / Repair procedures

Hyundai Elantra (CN7) 2021-2025 Service Manual / Body (Interior and Exterior) / Trunk Lid / Repair procedures

Adjustment

1.	Place the car on a flat surface and check whether the body and trunk lid are well - aligned.

2.	After loosening the trunk lid hinge (A) mounting bolt, adjust the trunk lid by moving it up and down or from side to side.

3.	Adjust the gap between the trunk lid and body by turning the trunk lid overslam bumpers (B).

4.	After loosening the trunk lid striker (C) mounting bolts, adjust the striker by moving it back and forth or from side to side and then tighten the mounting bolts.

5.	Make sure the trunk lid opens or closes properly.

Trunk Lid Assembly

Components and components location Component Location 1. Trunk lid assembly Repair procedures Replacement • When removing and installing the trunk lid, an assistant is necessary...

Other information:

Hyundai Elantra (CN7) 2021-2025 Owner's Manual: Outside temperature gauge

This gauge indicates the current outside air temperature by 1°F (1°C). -- Temperature range: -40°F ~ 140°F (40°C ~ 60°C) Note that the temperature indicated on the LCD display may not change as quickly as the outside temperature (there may be a slight delay before the temperature changes...

Hyundai Elantra (CN7) 2021-2025 Service Manual: Concentric Slave Cylinder Assembly

Repair procedures Removal1.Remove the manual transaxle assembly. (Refer to Manual Transaxle System - "Manual Transaxle")2.Loosen the bolts and then removing the concentric slave cylinder assembly (A) from the clutch housing. [Gasoline 1.6 MPI] Tightening torque : 19...

Air bag collision sensors

1. SRS control module/Rollover sensor
2. Front impact sensors
3. Side impact sensors (acceleration)
4. Side impact sensors (pressure)