| Special Service Tools |
|
Tool (Number and name)
|
Illustration
|
Use
|
| 09880 - 4F000 Hog ring clip installer |
| Hog ring clip installation |
Specifications Items Specification HoodTypeFront openine type, rear hinged, stay rod typeFront DoorConstructionFront hinged, frame door constructionRegulator systemWire drum typeLocking systemPin - fork systemRear DoorConstructionFront hinged, frame door constructionRegulator systemWire drum typeLocking systemPin - fork systemTrunk LidTypeTorsior bay typeSeat BeltsFront3 point type with Emergency Locking Retractor (E.
Components and components location Component Location1. Fender assembly Repair procedures Replacement • When removing the fender, wrap protective tape around a screwdriver or remover not to damage components• Put on gloves to prevent hand injuries1.
Description and operation DescriptionThe mode control actuator is located at the heater unit.It adjusts the position of the mode door by operating the mode control actuator based on the signal of the A/C control unit. Pressing the mode select switch makes the mode control actuator shift in order of Vent → Bi-Level → Floor → Mix.
Components and components location Components[This illustration shows the LHD type. RHD type is symmetrical.][Connector A] Pin No Function Pin No Function 1Low (Register specifications)4Middle Low (Register specifications)2Common (Register