Hyundai Elantra: Auto Hold / Warning messages
Parking brake automatically engaged
.png)
When the EPB is applied from Auto Hold, a warning will sound and a message will appear.
AUTO HOLD turning Off! Press brake pedal
.png)
When the conversion from Auto Hold to EPB is not working properly a warning will sound and a message will appear.
When this message is displayed, the Auto Hold and EPB may not operate. For your safety, depress the brake pedal.
Press brake pedal to deactivate AUTO HOLD
.png)
If you did not apply the brake pedal when you release the Auto Hold by pressing the [AUTO HOLD] switch, a warning will sound and a message will appear.
AUTO HOLD conditions not met. Close door, hood and trunk
.png)
When you press the [AUTO HOLD] switch, if the driver's door and engine hood are not closed, a warning will sound and a message will appear on the cluster LCD display.
Press the [AUTO HOLD] switch after closing the driver's door and hood.
Auto Hold
The Auto Hold maintains the vehicle in a
standstill even though the brake pedal is
not depressed after the driver brings the
vehicle to a complete stop by depressing
the brake pedal...
Anti-lock Brake System (ABS)
WARNING
An Anti-Lock Braking System (ABS) or
an Electronic Stability Control (ESC)
system will not prevent accidents
due to improper or dangerous driving
maneuvers...
Other information:
Hyundai Elantra (CN7) 2021-2025 Service Manual: Fuel Pump
Repair procedures Inspection[Fuel Pump]1.Turn ignition switch OFF and disconnect the negative (-) battery cable.2.Remove the fuel pump assembly.3.Check motor operation by fuel pump connector (A) connecting power (No.4) and ground (No.5). Pin No Discription 1Fuel sender ground2-3Fuel sender signal4Fuel pump (+)5Fuel pump (-)[Fuel S..
Hyundai Elantra (CN7) 2021-2025 Service Manual: Heated Oxygen Sensor (HO2S)
Description and operation DescriptionHeated Oxygen Sensor (HO2S) consists of the zirconium and the alumina and is installed on upstream and downstream of the Manifold Catalyst Converter (MCC).In order that this sensor normally operates, the temperature of the sensor tip is higher than 370°C (698°F). So it has a heater which is controlled by the ECM duty signal.When the exhaust gas temperature..
Categories
- Manuals Home
- 7th Gen Hyundai Elantra Owners Manual
- 7nd Gen Hyundai Elantra Service Manual
- System operation
- Maintenance
- Control Cable
- Tires and Wheels
- Dimensions, Engine specification, Bulb Wattage
Tire Rotation
To equalize tread wear, HYUNDAI recommends that the tires be rotated according to the maintenance schedule or sooner if irregular wear develops.
During rotation, check the tires for correct balance.
When rotating tires, check for uneven wear and damage. Abnormal wear is usually caused by incorrect tire pressure, improper wheel alignment, out-ofbalance wheels, severe braking or severe cornering. Look for bumps or bulges in the tread or side of the tire. Replace the tire if you find any of these conditions. Replace the tire if fabric or cord is visible. After rotation, be sure to bring the front and rear tire pressures to specification and check lug nut tightness (proper torque is 79~94 lbf·ft [11~13 kgf·m]).
