Hyundai Elantra (CN7): Infotainment System / Antenna

Shark fin antenna (1)

The shark fin antenna receives data transmitted from base stations and satelliltes (for example: GPS, Sirus XM, LTE) and also transmits to base stations (for example: LTE).

Glass antenna (2)

Your vehicle uses a glass antenna to receive both AM and FM signals.

WARNING

  • Do not clean the inside of the rear window glass with a cleaner or scraper to remove foreign deposits as this may cause damage to the antenna elements.
  • To prevent damage to the rear glass antenna, never use sharp instruments or window cleaner containing abrasives to clean the window. Clean the inside surface of the rear glass window with a piece of soft cloth.
  • Avoid adding metallic coatings such as Ni, Cd, etc. These can degrade the receiving AM and FM broadcast signals.
  • When putting a sticker on the inside surface of the rear window, be careful not to damage the rear glass antenna.
  • Do not put sharp instruments nearby the rear glass antenna.
  • Tinted rear window may affect the proper functioning of the antenna.

    You can use an USB port to plug in an USB. Information When using a portable audio device connected to the power outlet, noise may occur during playback.

    The steering wheel audio control switches are installed for your convenience. NOTICE Do not operate audio remote control buttons simultaneously. VOLUME (VOL + / VOL -) (1) Move the VOLUME toggle switch up to increase volume.

    Other information:

    Hyundai Elantra (CN7) 2021-2026 Service Manual: Mood Lamp

    Repair procedures RemovalMood lamp unit1.Disconnect the negative (-) battery terminal.2.Remove the main crash pad assembly.(Refer to Body - "Main Crash Pad Assembly")3.Loosen the mounting screws and remove the main crash pad air duct (A).4.Loosen the mounting screws and remove the mood lamp unit (A).

    Hyundai Elantra (CN7) 2021-2026 Service Manual: Description and operating principle

    Description and OperationWireless Power Charger SystemDuring ACC or IG ON, battery voltage is supplied to the wireless power charger system to transmit an output of 5 W to mobile phone. Mobile phones certified with the wireless charging standard WPC (Qi 1.

    Categories

     
    Copyright В© 2026 www.helantra7.com - 0.0214