| Components |

| 1. Rear door trim 2. Rear door delta inner cover 3. Rear door belt inside weatherstrip 4. Rear door module 5. Rear door belt outside weatherstrip | 6. Rear door frame garnish [RH] 7. Rear door frame garnish [LH] 8. Rear door body side weatherstrip 9. Rear door side weatherstrip 10. Rear door hinge |
AdjustmentGlass Adjustment • Check the glass run channel for damage or deterioration, and replace them if necessary.
Description and operation DescriptionThe mode control actuator is located at the heater unit.It adjusts the position of the mode door by operating the mode control actuator based on the signal of the A/C control unit. Pressing the mode select switch makes the mode control actuator shift in order of Vent → Bi-Level → Floor → Mix.
Description and operation DescriptionThe intake actuator is located at the blower unit. It regulates the intake door by a signal from the control unit. Pressing the intake selection switch will shift between recirculation and fresh air modes. Components and components location Components Location1.