Hyundai Elantra (CN7): Driving your vehicle / ISG (Idle Stop and Go) system
The Idle Stop and Go (ISG) system automatically and temporarily shuts down the engine when the vehicle is stopped and idling to help improve fuel efficiency and reduce exhaust gas emissions. (i.e. red stop light, stop sign, and traffic jam).
The engine is automatically started upon satisfying the starting conditions.
The ISG system is always active, when the engine is running.
Information
When the engine is automatically started by the ISG system, some warning lights (i.e. ABS, ESC, ESC OFF, EPS, and parking brake warning light) may illuminate for a few seconds due to the low battery voltage. However, it does not indicate a malfunction with the ISG system.
- To Activate the ISG System
- To Deactivate the ISG System
- ISG System Malfunction
- Battery Sensor Deactivation
WARNING Whenever leaving the vehicle or parking, always come to a complete stop and continue to depress the brake pedal. Move the shift button into P (Park) position, then apply the parking brake, and place the ignition switch in the LOCK/OFF position.
Prerequisite for activation The ISG system operates in the following situations. The driver's seatbelt is fastened The driver's door and hood are closed The brake vacuum pressure is adequate The battery sensor is activated and the battery is sufficiently charged Outside temperature is not too low or too high The vehicle is driven over a constant speed and stops The climate control system satisfies the conditions The vehicle is sufficiently warmed up The incline is gradual The steering wheel is turned less than 180 degrees and then the vehicle stops Information If the ISG light (white) is turned on on the instrument cluster and does not meet the ISG system operating conditions, the ISG system is not activated.
Other information:
Hyundai Elantra (CN7) 2021-2026 Service Manual: Specification
S
Hyundai Elantra (CN7) 2021-2026 Service Manual: Warning Indicator
Components and components location Components1. BSD Indicator2. Side repeater lamp Repair procedures Inspection1.Disconnect the negative (-) battery terminal.2.Remove the front door trim.(Refer to Body - "Front door trim")3.Disconnect the power door mirror connector from the harness4.
Categories
- Manuals Home
- Hyundai Elantra Owners Manual
- Hyundai Elantra Service Manual
- General Tightening Torque Table. General information
- Suspension System
- Rear Seats
- New on site
- Most important about car
