Hyundai Elantra (CN7): ISG (Idle Stop and Go) system / ISG System Malfunction

The ISG system may not operate:

When there is a malfunction with the ISG sensors or the ISG system.

The followings occur, when there is a malfunction with the ISG system:

  • The auto stop indicator ( ) will illuminate in yellow on the instrument cluster.
  • The light on the ISG OFF button will illuminate.

Information

  • When you cannot turn OFF the ISG OFF button indicator by pressing the ISG OFF button, or when the malfunction with the ISG system persists, contact an authorized HYUNDAI dealer.
  • You can turn off the ISG OFF button indicator by driving over 50 mph (80 km/h) for up to 2 hours with the fan speed below the 2nd position. If the ISG OFF button indicator remains ON, contact an authorized HYUNDAI dealer.

WARNING

When the engine is in auto stop mode, the engine may restart. Before leaving the vehicle or checking the engine compartment, stop the engine placing the ignition switch to the LOCK/OFF position or remove the ignition key.

    Press the ISG OFF button to deactivate the ISG system. Then, the ISG OFF button indicator illuminates. Press the ISG OFF button again to reactivate the ISG system.

    [A] : Battery sensor The battery sensor is deactivated, when the battery is disconnected from the negative pole for maintenance purpose. In this case, the ISG system is limitedly operated due to the battery sensor deactivation.

    Other information:

    Hyundai Elantra (CN7) 2021-2026 Service Manual: High Mounted Stop Lamp

    Repair procedures Removal1.Disconnect the negative (-) battery terminal.2.Remove the rear package tray trim.(Refer to Body - "Rear Package Tray Trim")3.Loosen the mounting screws and remove the high mounted stop lamp (A).Installation1.Install the high mounted stop lamp.

    Hyundai Elantra (CN7) 2021-2026 Service Manual: Evaporator Core

    Repair procedures Replacement1.Disconnect the negative (-) battery terminal. 2.Remove the heater and blower assembly.(Refer to Heater - "Heater Unit") 3.Remove the heater core cover (A) after loosening the mounting screws.4.Pull out the evaporator core (A) from the heater unit.

    Categories

     
    Copyright В© 2026 www.helantra7.com - 0.0112