| Components |

| 1. Cowl side trim 2. Front door scuff trim 3. Rear door scuff trim 4. Front pillar trim | 5. Center pillar upper trim 6. Center pillar lower trim 7. Rear pillar trim |
Components and components location Component Location 1. Front door scuff trim2. Rear door scuff trim Repair procedures Replacement[Front door scuff trim] • When removing with a flat - tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
Repair procedures Oil Specification1.The HFC-134a system requires synthetic (PAG) compressor oil whereas the R-12 system requires mineral compressor oil. The two oils must never be mixed.2.Compressor (PAG) oil varies according to compressor model. Be sure to use oil specified for the model of compressor.
Description and operation DescriptionThe intake actuator is located at the blower unit. It regulates the intake door by a signal from the control unit. Pressing the intake selection switch will shift between recirculation and fresh air modes. Components and components location Components Location1.