Hyundai Elantra (CN7): Rear Door / Rear Door Belt Inside Weatherstrip

Hyundai Elantra (CN7) 2021-2026 Service Manual / Body (Interior and Exterior) / Rear Door / Rear Door Belt Inside Weatherstrip

Repair procedures

Replacement
1.
Remove the rear door trim.
(Refer to Rear Door - "Rear Door Trim")
2.
Remove the rear door belt inside weatherstrip (A).

3.
To install, reverse the removal procedure.
   
•
When installing, install it by first contacting the inside part (basis point of assembly) of arrow to door frame.

    Repair procedures Replacement1.Pull down the rear door window glass to the lowest level by pressing the power window glass switch.2.Remove the rear door belt outside weatherstrip (A).

    Repair procedures Replacement[Rear door side weatherstrip]1.Loosen the rear door checker (B) mounting bolt. Tightening torque : 16.

    Other information:

    Hyundai Elantra (CN7) 2021-2026 Service Manual: Troubleshooting

    TroubleshootingProblem Symptoms TableBefore replacing or repairing air conditioning components, first determine if the malfunction is due to the refrigerant charge, air flow or compressor.Use the table below to help you find the cause of the problem. The numbers indicate the priority of the likely cause of the problem.

    Hyundai Elantra (CN7) 2021-2026 Service Manual: General safety information and caution

    General Safety Information and Caution1.Be careful when driving the vehicle using the smart cruise control system as follows.(1)On curves or inclines/declines• The smart cruise control system may have limits to detect distance to the vehicle ahead due to road and traffic conditions.

    Categories

     
    Copyright © 2026 www.helantra7.com - 0.015