Hyundai Elantra (CN7): Rear Door / Rear Door Latch

Hyundai Elantra (CN7) 2021-2026 Service Manual / Body (Interior and Exterior) / Rear Door / Rear Door Latch

Components and components location

Component Location

1. Rear door latch

Repair procedures

Replacement

1.	Remove the rear door module. (Refer to Rear Door - "Rear Door Module")

2.	Remove the rear door inside handle cage (A) by pulling it in the direction of the arrow.

3.	Separate the rear door outside handle connector wiring harness (A).

4.	Remove the rear door latch assembly (A) by pulling it in the direction of the arrow.

5.	Remove the rear door outside handle base (A) by pushing in the lock pins located in the back.

6.	Slide the locking pin (A) in the direction of the arrow to release the lock and then remove the rod (B).

To install, reverse the removal procedure.

•	Make sure the connector is connected properly.

•	Make sure the door locks / unlocks and opens / closes properly.

•	Replace any damaged clips (or pin - type retainers).

❮Rear Door Side Weatherstrip

Repair procedures Replacement[Rear door side weatherstrip]1.Loosen the rear door checker (B) mounting bolt. Tightening torque : 16.

Body Side Molding❯

Roof Side Molding Repair procedures Replacement • When removing with a flat - tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.

Other information:

Hyundai Elantra (CN7) 2021-2026 Service Manual: Heater Unit

Components and components location Component Location1. Heater unit assemblyCompoents1. Heater unit assembly2. Heater tube cover3. Heater core assembly4. Mode control actuator [LH]5. Dummy PTC6. Temperature control actuator [LH]7. Heater case [LH]8.

Hyundai Elantra (CN7) 2021-2026 Service Manual: Heater Core