Hyundai Elantra (CN7): DCT(Dual Clutch Transmission) System / Special service tools

Hyundai Elantra (CN7) 2021-2026 Service Manual / DCT(Dual Clutch Transmission) System / Special service tools

Special Service Tools
Tool
(Number and Name)
Illustration
Use
09200-3N000
Engine support fixture
(Beam)

Removal and installation of the transmission.
Use this beam (SST No. : 09200-3N000) with the supporter (SST No. : 09200-2S000).
09200-L1100
Engine support fixture (Rear)

Removal and installation of the transaxle.
with the beam (SST No. : 09200-38001/3N000).
09200-L1200
Engine support fixture (Front)

Removal and installation of the transaxle.
Use this beam (SST No. : 3N000) with the supporter (SST No. : 09200-2S000).
09200-4X000
Engine support fixture (Adapter)

Removal and installation of the transaxle.
with the beam (SST No. : 09200-38001/3N000).
Oil seal installer
09453-3L240

Used for installing differential oil seal Used with the handle (09231-H1100)
Handle
09231-H1100

Used for installing differential oil seal
Used with the installer (09453-3L240)
Inhibitor switch guide pin
09480-A3800

Used for fixing "N" range when installing inhibitor switch
Dual clutch remover
09430-C1180

Used for removing dual clutch assembly
Dual clutch installer
09430-2A240

Used for installing dual clutch assembly
Clutch actuator remover & installer
0K430-Q5100

Removal and installation of the clutch actuator assembly.
Clutch actuator adjuster
0K430-Q5300

Used for adjusting clutch actuator

    SpecificationsDual clutch transmission Item Specification Transmission modelD7UF1-2 (7DCT)Engine modelGamma II 1.

    Troubleshooting Trouble symptom Probable cause Remedy Displayed the warning lamp "E"(Driving is only possible with 1/ R gear)Not performed DCT learningPerform the DCT manual learning procedure.

    Other information:

    Hyundai Elantra (CN7) 2021-2026 Service Manual: Start/Stop Button

    Components and components location Component Repair procedures Removal1.Disconnect the negative(-) battery terminal.2.Remove the AVN Head unit.(Refer to Body Electrical System - "AVN(Audio Video Navigation) head unit")3.Loosen the mounting screws and remove the start/stop button (A).

    Hyundai Elantra (CN7) 2021-2026 Service Manual: Receiver-Drier

    Repair procedures Replacement1.Remove the condenser.2.Remove the cap (A) on the bottom of the condenser with a L wrench. Tightening torque : 9.81 - 14.71 N.m (1.0 - 1.5 kgf.m, 7.2 - 10.8 lb-ft) 3.Remove the receiver-drier (A) from condenser using a long nose plier.

    Categories

     
    Copyright В© 2026 www.helantra7.com - 0.0226